Aironet AP4500 Guia do Utilizador descarregar pdf (Página 35)

1 - 6 Ethernet or Token Ring Bridge

Installing the Ethernet Connection

NOTE: If you are installing a Token Ring Bridge, proceed to page 1-8.

The Ethernet Wireless Bridge supports three connection types:

n 10Base2 (Thinnet)

n 10Base5 (Thicknet) AUI connector

n 10BaseT (Twisted Pair)

è To Attach 10Base2 (Thinnet) Cabling:

1. Make sure the unit is powered off.

2. Attach the Thinnet cabling to each end of a BNC T-connector,

if applicable.

3. Attach the T-connector to the 10Base2 BNC (Figure 1.4). If the unit

is at the end of the Ethernet cable, a 50-Ohm terminator must be

installed on the open end of the T-connector.

CAUTION: Removing a terminator to install extra cable, or breaking an

existing cable to install a T-connector, will cause a disruption in Ethernet

trafﬁc. Consult with your LAN administrator before you change any

Ethernet cabling connections.

Figure 1.4 - Attaching 10Base2 (Thinnet) Cabling

10Base2

10Base5

10BaseT

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 222 223

Sem comentários

Aironet AP4500 Guia do Utilizador Página 35